How to use hookahs? 11 steps as follows:

Step 1:

 Add water to the cigarette bottle, and cover the metal pipe 0.8-1 CM. The water should not be too much, not more than 2 CM, otherwise it will be more difficult to smoke.

Step 2:

Connect the metal tube to the kettle body, and then connect the kettle body to the cigarette bottle firmly.

Step 3:

Put the round cigarette tray/hookah tray on the top of the pot and fix it.

Step 4:

Fasten the hookah grommets of the cigarette bowl on the grommets, then place the grommets on the grommets, and pay attention to the air-tightness; do not put too much force when placing the ceramic cigar bowl, otherwise it will easily cause breakage.

Step 5:

Put a pipe shisha grommet on the pipe mouth of the pot body, connect the wooden end of the pipe to the black rubber mouth, and pay attention to the air seal; if it is a multi pipe, connect the other pipes in turn.

Step 6:

Sprinkle the shredded water pipe on the ceramic smoking bowl to keep the smoke smooth, pay attention to not putting too much shredded tobacco; and it is recommended to leave a little space between the top of the shredded tobacco and the bottom of the tin foil.

Step 7:

Cut a square foil to wrap the entire ceramic cigarette bowl/hookah bowl with the smoke material in it, pinch tightly to keep it sealed, and pierce some small holes in the foil with a toothpick or one end of a carbon clip.

Step 8:

Use a hookah tongs to clamp a special charcoal for hookah, use a lighter to burn the charcoal red; note that the black part of the carbon is not burned at this time, you can start to inhale and spit out with a straw, which can accelerate the carbon to burn through, but do not inhale at this time Into the lungs.

Step 9:

Cover with a windshield. If you are enjoying the hookah outdoors, the windshield can prevent the wind from blowing off the charcoal dust.

Step 10:

Put the disposable mouthpiece on the pipe and try to take a few puffs; at this time, the charcoal may not be fully burned. You can start to inhale and exhale to accelerate the charcoal burning through, but do not inhale into the lungs.

Step 11:

The air valve is used to prevent gas from entering the smoke bottle. When there is a free smoke pipe opening, the valve should be blocked with a small steel ball.

So all of you know how to use hookahs?

Related posts